Sensaphone WEB600 Upgrade instructions Manual de usuario descargar pdf (Pagina 3)

WEB600 Firmware Revision History

• Corrected an issue on the web page with the white min/max bars not displaying correctly on the bar

gauge.

• Corrected an issue on the webpage with the Schedule pop-up on the Profile screen.

Version 1.52 (June 5, 2012)

• Fixed a web page issue when disabling a zone which caused the zone programming link to disappear

on the Zones page.

Version 1.51 (April 27, 2012)

• First release.

Original WEB600

Version 1.46 (June 22, 2011)

• Fixed programming Save/Load compatibility issue when loading programming from older firmware

versions.

• Increased the allowable time range for the Alarm Hold Time function.

• Added a Reboot button to the Admin screen to restart the device

• Changed the default Time Server to time.sensaphone.com

• This version requires the latest MIB file for SNMP access

• WARNING: Installing this update will reset the unit to factory defaults.

Version 1.43 (January 21, 2011)

• Added the Alarm Hold Time function.

• WARNING: Installing this update will reset the unit to factory defaults.

Version 1.41 (December 10, 2010)

• Added support for custom dry-contact descriptions depending on the position of the contact.

• WARNING: Installing this update will reset the unit to factory defaults.

Version 1.40 (November 19, 2010)

• Added a “Message failed” event for cases where the email server could not be contacted.

• Fixed a problem where email messages would fail to be delivered on certain networks.

• WARNING: Installing this update will reset the unit to factory defaults if the current firmware

version is v1.30 or less.

Version 1.39 (July 15, 2010)

• No functional change - maintenance update only

Version 1.38 (April 26, 2010)

• No functional change - maintenance update only

Version 1.37 (April 19, 2010)

• Changed the e-mail functionality such that messages are considered successfully sent once the

protocol says it is sent, even if the connection closes non-gracefully.

• WARNING: Installing this update will reset the unit to factory defaults if the current firmware

version is v1.30 or less.

Version 1.36 (February 2, 2010)

• Fixed an issue where the last character in an alarm message was cut-off.

• Fixed a network issue where the HTTP connection would sometimes freeze.

1 2 3 4 5 6 7

Sin comentarios

Sensaphone WEB600 Upgrade instructions Manual de usuario Pagina 3