2 WEB600 Firmware Revision History
WEB600 Embedded Firmware Feature and Correction Summary
------------------------------------------------------------------------------------------------------------------------------------
NOTE: This document covers both the original WEB600 and the new WEB600 with Relay Output. The
firmware files ARE NOT compatible. Pay careful attention to select the proper file when performing a
firmware update. Contact Sensaphone Technical Support if you have any questions: (877)373-2700 or
support@sensaphone.com.
------------------------------------------------------------------------------------------------------------------------------------
WEB600 with Relay Output
Version 1.59 (July 15, 2013)
• Corrected issue which prevented the Battery Low Limit from being displayed.
Warning: If you are upgrading from 1.56 or earlier, the Alarm and Table Limits will be off by a
factor of 10 if you reload your programming from a saved programming file. Check your zone
programming and adjust as necessary.
Version 1.58 (July 8, 2013)
• Added support for extended precision when using 4-20mA sensors. Sensors can now read to two
decimal places.
• Enhanced datalogging such that samples are now recorded evenly at fixed times on the hour, minute,
and second. Removed extraneous datalog entries.
• Corrected issue which caused false error messages to appear on the Zone programming screen.
• Enhanced the gauges on the summary screen to account for small values.
Warning: If you are upgrading from 1.56 or earlier, the Alarm and Table Limits will be off by a
factor of 10 if you reload your programming from a saved programming file. Check your zone
programming and adjust as necessary.
Version 1.56 (December 6, 2012)
• Corrected a problem that could cause e-mail messages to fail under certain conditions. When the
unit attempted to send e-mail or perform time synchronization while the network connection
was unavailable, the unit could potentially fail to send e-mail messages - even after the network
connection returned.
• Corrected a scaling problem with the bar gauge when used in manual mode.
• Corrected a problem with SNMP traps.
Version 1.55 (October 24, 2012)
• Changed the web page timing to allow the page to load over slow and/or high latency connections -
such as a cellular or satellite uplink.
• Fixed DHCP to support DHCP relay agents.
• Added Pulse Count as an input type with a programmable coefficient for scaling.
• Removed the ability to change the input order on the Zones page.
• Changed the datalog export function (csv & xml) to include proper zone ID numbers.
• Corrected an issue on the web page where the bar gauge upper and lower limits would not adjust
properly when set to Auto mode.
(32 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales